How to calculate power dissipation in ltspice
- how to measure current in ltspice
- how to find current in ltspice
- how to calculate current in ltspice
- how to measure rms current in ltspice
Ammeter in ltspice.
I suggest you upload a simple example of the fault and tell us you did that.
On 2025-01-07 16:59, Rob wrote:
-- OOO - Own Opinions Only Best Wishes John Woodgate Keep tryingThanks Tony for the suggestion. I went thru all the Settings screens and I set "save currents".
Ltspice current probe direction
Ltspice current probe direction Ltspice current source Ammeter in ltspice Ltspice power measurement Current probe ltspice But my system operates the same: when I hover cursor over the ends of a component I get a voltage probe which works fine when I click it. But hovering over the center of a component does nothing as it always has with the current LTSpice installation.
Perhaps my mouse isn't working correctly but it has performed normally otherwise for me for a year or so. I'm stumped... Rob
What kind of component did you hover over?
It depends on whether it is:
- A 2-terminal part like a resistor,
- A 3 or more pin part like a transistor or IC,
- Or a sub circuit model (custom part).
Did you remember to save the settings, and then run the simulation again?
Andy
Rob,
Just to be clear about this:
That LTspice setting affects whether or not the currents are saved in the .RAW output file whe
- how to measure voltage and current in ltspice
- how to find mesh current in ltspice